How to Reduce 12 Volt to 6 Volt

How to Reduce 12 Volt to 6 Volt

Electronic gadgets generally operate at lower voltages than the one at which electrical energy is supplied, so they may also have interior circuit factors that step down the source voltage. If you have a device lacks this type of interior voltage protection, you can grant it by using establishing an external resistive voltage divider circuit. It’s feasible to step 12 volts down to 6 volts by way of incorporating a pair of 10,000-ohm resistors into the circuit.

 

Cut two lengths of wire, and strip each wire of half an inch of insulation at every end. Attach one give up of the first wire to the tremendous terminal on the strength supply. Attach one cease of the second wire to the terrible terminal on the power supply.

Attach the second lead of the first resistor to the first lead of the second resistor, and twist the wire leads together. Attach the first lead of the first resistor to the free cease of the first wire, and twist the lead and the wire together. Attach the second lead of the 2nd resistor to the 2nd wire, and twist the leads together.



Turn on the strength supply. Attach the pink (positive) multimeter probe to the joint between the first and second resistors. Connect the second lead to the black (negative) multi-meter probe to the welcome. Turn the multimeter to “Volts DC.” The voltage reading need to be about 6 Volts DC

Be the first to comment

Leave a Reply

Your email address will not be published.


*